Hardcore Sledder banner
1 - 7 of 7 Posts

·
Registered
Joined
·
279 Posts
Discussion Starter · #1 ·
well, i bought a speedwerxs pipe off a 2005 f7 for my 2004 f7 and the guy told me that i would need a exhaust bracket because of it being a 2004, he told me The mount is Arctic Cat #1712-141 and is like $14. Just rivits on the frame brace. he told me... i bought one but it didnt show any pictures online, does anyone have pics to were i will be mounting this?
 

·
Registered
Joined
·
1,248 Posts
slide it along the bulkhead until you find the spot that best supports it. I found my bracket to be too low to properly support my Speedwerx pipe and added a piece of belt on top to make it a bit higher.
 

·
Registered
Joined
·
1,154 Posts
INSTALL THE PIPE THEN PUT THE BRACKET UNDERNEATH IT. YOU WILL SEE WHERE IT LINES UP TO THE PIPE BRACE. THEN DRILL YOUR HOLES AND RIVET IT ON. :thumbsup:
 

·
Registered
Joined
·
871 Posts
I just used the ball mount on mine. The ball would fall out once in a while so I put some high-temp silicone in the cup and put the ball back in and no problems since.
 

·
Registered
Joined
·
1,031 Posts
Her you Go.
 
1 - 7 of 7 Posts
Top