Hardcore Sledder banner

1 - 2 of 2 Posts

·
Registered
Joined
·
188 Posts
Discussion Starter #1
when taking out valves did anybody ealse have to remove the 4 studs to get the cap housing off? I did and I am going to replace with cap screws!
 

·
Registered
Joined
·
17 Posts
No, I did not have remove the studs.

Be sure to check your cable length. one of mine was about 1/8" longer than the other. This particular valve was the one that I had to beat out with punch after I removed the cylinder. proper cable length is 1-1/4" to 1-3/8".
 
1 - 2 of 2 Posts
Top