Hardcore Sledder banner
1 - 4 of 4 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
I am having an issue with my M6, I put in the quite performer kit from Bikeman and had lake race porting done, boondocker control box(got settings from Bikeman), stage 2 supertip clutch kit with 72 gram weights, primary spring green and secondary spring orange in third hole and a 40/36 helix with wot at 7900 to 8000. This thing honks till it hit about 6200 and it falls on its face like it is cutting out. Does anybody know what is wrong, tried emailing Bikeman but haven't got a response yet.
 

·
Registered
Joined
·
10 Posts
Had a similar problem with my M6 after installing an 800 big bore kit. Screamed like scalded ape to just over 6000 RPM then fell flat with check engine light flashing codes that cleared when engine turned off and restared. Turned out that the power valve cables had slipped out of the grooves on the servo, so ECU went into limp mode when trying to actuate APVs. Recommend you check power valves/cables/servo.
 
1 - 4 of 4 Posts
Top