Hardcore Sledder banner
1 - 6 of 6 Posts

·
Registered
Joined
·
250 Posts
Discussion Starter · #1 ·
just took my sled out and noticed the code for no servo motor. when i got it in the garage i found that all the lights were burnt. do you think this is the voltage regulator. if it is where is it. or is it all done thru the ecu. could i have damaged my ecu
 

·
Registered
Joined
·
1,240 Posts
I caught mine before it blew all the bulbs. I think it was about $75.00 for a new regulator. It is the left side bearing end cap for the track drive shaft. Peace,beeler
 

·
Registered
Joined
·
306 Posts
Buy the regulator from a -05 or -06 F-cat, thats what i did. The regulator is wery expensive and from the newer one cost about half (in sweden)
 

·
Registered
Joined
·
250 Posts
Discussion Starter · #5 ·
thanks guys i fixed it i guess when i went to change the track it got unplugged. plugged it back in and seems to be ok
 

·
Registered
Joined
·
1,240 Posts
Glad thats all it was. Must mean the computer has pretty good over voltage protection built into it. Peace beeler.
 
1 - 6 of 6 Posts
Top