Search Results for ‘suspension setup’

Hi all very first sled purchased this year 2002 Polaris edge 700 with 136 conversion. Sled runs great and so far put about 400 miles on so far. I upgraded my carbides to 7.5 shaper bars and noticed that I now feel tippy and get much more ski lift around corners. I don’t seem to push through...

I have a 02 800 xcsp and I recently put a 136" iq skid in it and didn't notice till I went to test ride it that the track is 2.86 pitch, I have the drive shaft from the iq/shift before I go pull it all apart again I was just wondering if anyone knew if the 2.86 drive from the iq would work in...

I have an 08 chassis iqr with 600 swap. I'm bottoming out the skid bump stops just standing on the sled ~235 geared up. Wondering do I have to go with IQR torsion springs or is there a edge/prox spring that is known to also fit the IQR skid? Reading a lot about .375 from the edge is a great one...

I have a 2012 xf turbo 1100. I got the sled already set up for drag racing. The rear suspension is out of a 2018 and sits real low. The limiter straps have been removed but the suspension does not drop all the way down when the sled is off the ground. I’m sure something was done to it but I...

Hey guys, I have a 2010 rush. I bought it from a guy about twice my weight and backed off the rear track spring. The ifs and the front track shock are set to factory. I weigh maybe 135 with gear. I know I need a little more ski pressure but as far as handling it's decent. I ride very forward and...

Hi everyone! I just bought a 2010 rush 600. I rode about 150kms and definitely need to make some tweaks. I have read many posts about adjusting the suspension but i am having a hard time figuring out exactly what I need. I don’t have the RTS suspension gauge . Does anyone have a picture or know...