HCS Snowmobile Forums - View Single Post - 2002 ZL 600 EFI servo cycle issue
View Single Post
Old 01-20-2017, 06:44 PM   #8 (permalink)
CentralMaineMan
Member
 
Join Date: Jan 2017
Posts: 16
Current Sled(s): 2001 ZL 800 ESR
Previous Sled(s): 2002 ZL 600 EFI/ESR
Location: Maine
Favorite Riding Area: Central and Northern Maine
Default

Still have not figured this out. My voltage was low on the regulated side down to 8-10 volts so I pulled the regulator plug to let it run on the output of the stator. At idle it was 12-14 volts. I plugged the brown and yellow feed back in for the power valve servo and it stayed idle for maybe 20 seconds then the actuator cycled and the engine dies. After it stopped and I was trying other stuff plugging that power in was acting just like a kill switch. It would kill the engine immediately. Where in the harness would that brown and yellow be able to screw up and act like a kill switch? I have contacted Stator Kevin and he said the numbers I am getting on the stator are correct and the output on the lighting circuit is correct also. Thanks for any advice.
CentralMaineMan is offline   Reply With Quote