Ok my #15 bushing was installed wrong from the factory or is this parts break down inaccurate? My bushings were installed against the inside of the torque arm not the tunnel side? This is the bushing on the front holding the suspension to the tunnel. Pics a little fuzzy but partsland.com has it larger if you need to look closer.

The proper way is install the the torque arm in the tunel than put the bushing in,the parts break-down you have is incorrect.

Thanks Brock thats what I tought glad to here I don't have to pull the skid again.

Brock is right. That exploded view is wrong!

I ran into this myself this past fall as my 03 Polaris service manual also contains this same incorrect exploded view.

After some butt scrathing I came to the conclusion that the bushing can only go in from the torque arm side anyway or there wouldn't be any surface for the bolt to bear against.