I am working on a friends sled for him and for some reason the head of the bolt that holds on the lower gear in the chain case broke off. I used a right angle drill attachment and drill ed a hole with the drive shaft still in the sled. I then broke off the easy out in the hole so now what?

Will I be able to remove the drive shaft and the drive sprockets without removing the track and rear skid?

I am hoping for a quick remove shaft and drill thru bolt and easy out for a re tread.

It looks like I should be able to do it if I can get the shaft to slide tward the clutch side and then angle out the chain case side.

Any help would be great this weekend is our last chance to ride before the end of the season so I am hoping it's going to ge able to get fixed :beer2:

Thanks for all the help Polaris experts

you seem a bit impatient. Not a lot of action on here lately. Pull the skid then pull the shaft. Chain case can stay in just tap the shaft from the speedo side to knock the bearing out

Thanks that was what I was thinking I would have to do. Sorry I am a little impatient trying to get this thing fixed for him so we can ride this weekend.
Thanks

may wanna replace bearings while at it ????

Thanks for your guys help. I was able to drop the skid and get the drive axle out and took to a machine shop $80.00 bucks later and all I gotta do is put it back together and a ridin we will be !!

80 $ damn
i got a drive shaft i would have sold ya
for half of that