i need carbs for my xc i think they are 39mm... or if u no how too repair them let me no...cuz inside where the float pin is the lil tower is broke off and we tried too epoxy it back together and it jus broke off again... so now im lookin for new or used but if used they have too be able too get put on and be able too drive it with out any problems.....

check out swap meet on here and on www.snowest.com, should be able to find one

I have a 98 xc600 motor complete with carbs,cables, electrrical,etc.. if you want some carbs,let me know.

hey gen2
how many miles are on the motor?? how much would u want for the carb the motor and electrical??

I had the tab break on a motorcycle a few years back. Found a guy to weld the piece back on for me and had to grind and drill a new hole. has held up for almost 5000 miles now. Wasn't to hard with a dremel and a few accessories.

It had a ring turn on the mag side cyl and grooved the nicasil. It will need a cyl repaired and 1 piston. It didn't hurt anything else as there was no debris floating around the engine.the sled was still being ridden but became hard to start , when we discoverd the weak cyl. It has less than a few hundred miles on a brand new stator, water pump belt, and new water pump seals and impeller.I'd consider $500 for it. the bottom end is the same as a xc700 and i might just put a 700 top end on it and sell the good xc6 jug/piston/head.

i have a 99 600 big block that was rebuild for project sled that has not happened yet.i have carbs(mikunis) and a set of twin pipes & silencer.no cdi if you are interested.i also have 2 carb bodys cheap