How high can I go with risers and FLY mini bends?

Doesn't look like the mini bends and 4 inch FLY risers I took off my REV are going to fit.


Going on a 2008 IQR 600. Would like to stick with stock cables. Should I go with FLY 2 inch risers and Mini bends?


tks for the help.

D.J.

i have the stock bars and a 2 inch rox on top of the stock riser not sure i would go much higher then that i think the chassis handle weird with tall bars there way tippy

are u talkin on top of the stock riser or adding new riser all together cause with taht i would think that the 4 inch and bars would be close

I had a 4" rox riser with fly aero taper bars and I had to reroute a few things but you will have to buy a longer throttle cable. They are cheap since it is only going to your carbs and not to the oil pump. I ended up taking off the fly aero taper and went with fly straight bars since it was too tall and mad the sled really tippy. I love how it handles with 4" rise and straight bars. I am 6'3" and so I needed the extra height.

I am going to order fly 2inch riser with my mini bends.


Can any one let me know if I will have problems with stock wiring. 4 inches didn't look like it was going to work and the bars are way up there. I am 5'10. Looked cool but not practical.

I just rerouted my wires and did not have to any mods to the wires to make them work for my rise. I think you will be ok since they come with a 4" rise stock with straight bars. With mini bends and a 2" rise you should be ok with just rerouting the cables and wires to make it work.

I have a 6 inch riser with straight bars and every thing fit.