Im switching from 10-62s, to some used 10-60s I picked up. One of the weights almost needs to be pressed onto the pin. Should I find another weight??

Just take some fine sand paper and clean up the bolt a little. You want it to turn free.I hope this helps. Dan

run a 1/4" drill bit threw the bushing

I ended up ovaling one of the arms out with a drill bit. One thing that didnt help was that I got the updated pin pack that comes with new arm pins, bushings and nuts. These new pins though nice thats its a torx head...isint nice that they are slightly fatter.

put pin in drill press, spin up and use emery cloth to take the coating off pin. pin should run free, ovalling of the bushing is not a good idea. there are bushing kits available for the weights. if ya have run a drill bit thru already, the bit may cause some roughness. run the solid part of the bit thru at higher speed to try to even it.