Had a stud pull through on my 2000 T-cat. What track would you guys suggest. I would like to re-use the studs that are in it seeing as there's 240 and there in good condition,therefore I will need something close to the stock lug height. It will be used as a trail sled and a grudge lake racer if that helps. Thanks

I have always had great luck with the camoplast predator tracks, fully clipped. The hack saw is a good track, and you can save a few pounds with it, but I have not found to be as resilient as the predator. Also, I would not put 240 studs on a new track. Since we have always seemed to pull the studs from the outer edge, we have been putting 144 down the center without issues.

I put a 1" predator track on my 99 T-cat, and it worked 10x better than the stock track. JT

I think I'll lose too much stud penetration with a 1'' track if I use the existing studs.I wish I could go with a bigger lug,just dont want to spend $400.00 on studs if I do

didnt the 00 have a 1" track? I dont remember. JT

I think it had the .85 track. If you want to go with the stock, there are many out there at reasonable prices from online retailers.

is there a web site that would tell me the exact lug height??ifso....what?? thanks

Amphibxp, your right the 00 tcat came with the .85 lug track.

Wis400x

I have a stock tcat track with 240 pics. 1300 miles on it. No tare outs very good shape. If you are interested $75.00 plus shipping. I"m in New York.

IF its not gone yet PM me asap. Thanx, Jeff.

THANKS FOR THE REPLY.I WOULD LIKE TO BUY A NEW TRACK THOUGH

I wouldnt be too concerned with 1 pull out, especially if it was on the inner part of the track. If it was on the outer edge then replace it.

its bad,definately need a new track.