We finally got some snow so I can go ride again. Sick of paying the money for 110 octane so I got the low compression head. Got it all ready to go back together but the instructions didn't have torque sequence for head bolts. Was wondering if anybody knew it off hand and I really really would appreciate a quick reply. There is tons of virgin powder to go ride on.


Thanx in advance....

the manual i got says for the cylinder head torque to be between 20-24lbs/ft :div20:

Thanks for the reply but I know the torque specs. What I need to know is what order do you torque the bolts down. If you have the manual then it should have this info and I would greatly appreciate it if you could find time and look it up for me.

whoops...sorry bout that....alright here we go:
---5-------8
9----1 4----12
10---2 3----11
--6--------7

Thanks man, I got it all done today and it runs great. I figured after somoe of the nightmare stories on here that I would have problems getting it bleed but it was cake.