i have an 07 racer roller i bought and putting in my own motor and the twin pipes use different holes than the ones already drilled in the sled. i dont want to drill even more holes so here is my question.

can i change the angle/lengthen the silencer tubing that connects to the pipes to make them reach the holes already drilled in the sled? or will this change how the pipes run?

so what i am basically asking is after the stinger at the end of each pipe, after the silencer slips on, can i change the angle and length of the pipe to the silencers so they will go out the already existing holes drilled in the bellypan, or will this change performance or not enough to notice anything...