I just installed a slp torque stop and a wms torque arm. When I went to loosen the front pto mount i think it snapped in half or was already bad because i know that is common. Anyway I cant see the bottom bolt to get to the motor mount to remove..

also on my wms torque arm it has a rod eye that bolts to a block that pivots on the plate that bolts to the motor. When I pry up on the motor that assembly moves even after i tightened the bolts. Is is supposed to pivot ? Does this rambling make any sense ?

LOL no take some pix...it should piviot up and down just not towards and away from the secondary. If the mount is broke take the other 3 nuts off and yank the motor.

The engine mount screws directly into the bulk head. Polaris has a special engine mount socket to remove them. However a Dana axle front hub nut socket will work also.