I have a 95 440 FC Bearcat, the right side will not fire when idling, when at 1/4 throttle both sides fire.

I've pulled both carbs soaked them and cleaned them, no response.

I'm looking for the correct carb adjustment for both sides?

I sounds to me like either the throttle safety switch is bad, . (The little plastic 2 wire switch located on the side of the carb.) Or the slide may be turned in the carb barrel and is not reaching the home position- this will cause the safety to shut down the cylinder whe the throttle handle is released.

Thanks,

I've dettached and re-attached both sides, cleaned the contacts, already done the carbs, everything seats nicely, opens and closes just fine, no sticks or shudders on the way up or down.

I guess I'll have to go to the dealer to check the electronic part.