Just got my rails back from being welded up and I'm ready to put the skid back together but I don't have the torque specs for assembly.

Out of habit I always torque everything and use loctite as needed to be safe.

I don't want to see egged out rail holes again so I want to be sure everything is to spec.

Front Arm to tunnel:
Rear Arm to tunnel:
Front arm to rail:
Rear Arm to rail:
Center shock mount to rail front and rear attachment points: (these were the problem holes that were welded)
Center shock mount - swing bracket to center skid mount:
Rear axle:
Idler wheel assemblies:
Front limiter strap mount to rail:

Any tips on keeping everything snugged up?

Thanks in advance! :beerchug:

It is the same skid as the 6 and 700's if any one knows the specs for them.

Thanks,

This was just on here a couple weeks ago,try a search.I dont recall myself I just go by feel & check them often ,maybe not the best way .

I tried searching and no luck before I posted this.

I want to insure that everything stays snug and I'm not into another rail repair.

This isnt the one I was talking about but it should help
http://www.hardcoresledder.com/forums/inde...7&hl=torque

Thanks, It is appreciated.