Was in the process of replacing the Drive Shaft Bearing, got the old one off fine. Put the new one on then locked the collar temporary but not fully tighting with the allen wrench. Was attempting to put the drive shaft in Clutch side full, and the bearing slid down the shaft about 1/2" from the end. Now I cant get nor move the bearing back to where it should be...


Help!!

Thanks


JamaC

Take the shaft out again and remove the speedometer adaptor. Tap the end of the shaft against a wood block straight down to move the bearing off the shaft. Take the collar off and wire brush the surface to remove any gouges. Lightly oil the shaft for reassembly.

Heres a pic

Is the bearing jammed on the race?

I can't tell from the picture if the bearing is crooked.

Nevermind got it out using a 2 prong gear puller. the lock collar got tightend and was against the other side so could not unlock it. Just finished putting the sled back together.

JamaC

:div20: