For what it't worth, I just thought I'd share my instalation pictures so you can get an alternative to what has been posted previously.....

Click to view attachment
Click to view attachment
Click to view attachment
Click to view attachment

should you ever get condensation ,moisture in the bottom of those loops, and freezes
or if fuel backed up into the hose, from say a needle had something under it or from being on its side.
itll go lean,

havent looked at instructions for a while ,but im sure it says to keep the lines so theyll drain for that reason


EDIT: im sure you did that to use up the hose, i ran the first 2-3 years with about 10-12 inches of hose only, without troubles,
because all that extra hose was a pain to route

So how would you propose looping 24" of hose so they'll drain, while not coming into contact with any hot engine parts! Hoses are a good eight inches above float bowl vents.....

read my edit:
i know for a fact you dont need 24"
when i first installed mine the instruction said 18". i found that a lot so i went with 10-12 dont recall.

but i do know as i said, you get a restriction in the bottom of those loops, she,ll run REAL GOOD for a LITTLE while.

Hey, it looks like a nice install, go for it.