Just got my reverse kit and the bottom gear is 44T, stock is 43T. How much is that going to change my gear ratio? I was going to drop 1 tooth on the top for better bottom end, should I go 2 now? or more? Or should I see if I can order a 43T reverse gear and keep it stock?

Sled is a 99 Formula 111 600
all stock
144 studs
I ride aggressive and would rather have alot of pull than top speed

Thanks
Rick

Going one T larger on bottom gear is = to going one T smaller on top. the setup you have(with the rev.) will give you the results you wanted(dropping one tooth on top) and keep proper chain tension. :div20:

With the revers you can only get the 44teeth bottom gear. Just use this and you will get more out of the corner`s.

Reverse uses a 44 bottom tooth like the guys above said.

Going up 1 tooth on the bottom = Going down 1/2 of a tooth on the top sprocket.