drive shaft install on the bearing/clutch side i cant remember how the order of how the parts go on...

starting from the sprocket/track side i know the flange with the 3 bolts goes first as that is the only way it can go as its on the track side of the bearing but does the next flange go on the tunnel side or inside with the clutch side??? and then the gasket and speedo housing??? cant remembr what side the middle flange goes on: the tunnel side or inside with the speedo housing.....

parts 30 33 35 36 in below pic

33 is the bearing holder mates up to the bearing on the outside of the tunnel with the speedo cable housing.. 35 is the gasket.. in between
36 speedo cable housing and 33 bearing holder..

Make sure you line up the pin holes of the bearing with the grease hole of 33
the the grease zerk hole from the speedo cable housing..

well i got it right then except for the damn grease hole didnt know there was such a thing i just slapped it together and greased it....thx