newbe proxr800
Oct 12 2006, 07:07 PM
I recently purchased a torque arm and a push arm for my 2004 proxr800.Do they just bolt in,or do you have to drill holes.Are they hard to put in?Thanks :beerchug:
xc-mark
Oct 13 2006, 03:17 PM
the PTO side you need to remove the primary but all the holes are there, also use locktite on the block bolts! The mag side you need to drill a few small holes , its very easy to install.
just-pinch-it
Oct 13 2006, 04:28 PM
Definatly use both. I used only the push and I broke still broke the PTO side front mount.
xc-mark
Oct 13 2006, 07:04 PM
Pto side is the most important side...... Prox sleds break the front pto mount 90% of the time first.
n2oiroc
Oct 13 2006, 07:32 PM
you will probably need to unbolt the front mounts and lift the front of the motor up a bit to get the bottom pto bolt in. taking the clutch off makes it easier, but its not necessary.
just-pinch-it
Oct 14 2006, 07:40 AM
Iwould take a good look at that PTO motor mount first. It's probably trashed already or near to it.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please
click here.