Noodle
Sep 17 2006, 06:40 AM
A friend asked me to help with cleaning and adjusting his carbs. What would be a good base setting for the screws and jets. It will be used from 0-2000ft, and must be safe. Thanks for any replies.
bradley
Sep 17 2006, 06:30 PM
do a search for 500's....this ws a topic just alitlly while ago check like maybe page 5 and higher....some one will anser to this is an awsome website!!!!!!!!
Noodle
Sep 25 2006, 07:46 PM
ttt
high5
Sep 29 2006, 11:12 AM
370 mains -20 to +10 /350s for +10 to +40/330s for above 40
45 pilot
9FH4-57-3 jet needle
P-6 needle jet
1.5 cutaway
2.0 pilot screw
1500 rpm idle
Youll have to play around with your mains and clip position cause she likes to be jetted tight. She should pin out @ 8250 no more than that. It might have a little low end stumble @ slow trail speeds (around 5000 rpm) for which I never did cure.
Anyways I hope this helps and tell your friend to enjoy! :div20:
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please
click here.