Hey Guys

I just wanted to know if anyone on here knows a good place in the Peg to get some powder coating done?

I'm going to do some changes to my 79 750 Special, and am looking to get a bunch of parts coated. Any idea roughly what the cost on getting this stuff done is?

Central Sandblasting on Gunn Road. Does a good job and is reasonably priced. They did the A-arms for my F7.

Yeah, had these guys do my race car chassis, they do real good work.

I don't even have a clue what kind of price tho...camel...how much to do a-arms? that'll give me a rough idea what i'm looking at

i got mine done at PPC. its not really meant for comsumers though.

check it out

http://www.thumpertalk.com/forum/garage.ph...achmentid=15991

LOL, you have a dirtbike in your living room? Now THAT'S hardcore. I'm lucky if my parents will let me keep the sled in the garage this summer.

But back on topic, how much would it be to do a set of A-arms? Mine are getting rusted.

industral coating is pretty cheap, this place i went to was doing a bunch of beds for stony mountian penatentury, so i taped a few files underneath them, j/k

If I'm not mistaken it was about $80-90. That was for sandblasting and powder coating, that price included sandblasting my pipe too. Make sure you take your spindles apart and clean all the grease out as best you can, and then put them back together before you take them in. If you don't get all of the grease out it'll run the finish. Don't forget to get your ski saddles done too.

do they have lots of colors to choose from? I got my suspention parts done at Winnipeg Wheel works and they had to order the paint in.

the job cost me 150 at Winnipeg Wheel Works and that included the sand blasting so i got a good deal
Its the green that was powder coated
Click to view attachmentClick to view attachment

Ouch..150 for those 2 little pieces...

Yah, they've got other colors. If they don't have the color you want, they can get it. It's cheaper to go with black.

it would have been 100 but they had to order some paint in for me. I was 3 peices, front skid swing arm and the rear swing arm is 2 paices

the other parts i want to do this summer are going to be black so shouldnt be too bad. I want to get my rails powdercoated black, not sure how much its going to cost me though