Ok, heres the story, 1500 miles ran fine in Nov when I bought it, was serviced last year by dealer and ran fine. I put some stabil and sea foam in the gas, too much. Wont not start and then finely did after draining gas and refueling it with new. The carbs have been cleaned 3 tiimes and new seat and needles, new primer pump and lines, new rave boots and the air box and exhaust are clean. Idles and starts fine, very slow response to throttle and when hits 4000rpms and starts to engage, it smokes and bogs and wont move and I have to let off gas or it will die. The sled will run on each cylinder when I take the other plug cover off. But, I did notice that the spark was jumping from the rt wire to the motor when unhooked from the plug. Also, that same pipe has oil and is wet at all the exhaust joints. Anyone have any ideas. I have new pugs wires and caps ordered but wont be here until friday and I any wondering if I need to try or get anything else. Any help would be appreciiated. The shops are two weeks out and the snow here is melting fast. Would like to put at least 10 miles on before xmas. Oh, I almost forgot. When I put new plugs in and had the airbox off, I could actually go about 20 miles per hour but then it would lose powere and I would have to idle for a while before trying to go again. THanks CY

sounds like shes floodin and bad. jet fall out or sumthin? does it idle? just sounds like shes gettin waaay too much fuel

has new seat and needle which controls the fuel intake. What else controls the fuel? Idles great, has slow pickup when given more throttle.