I melted down the PTO side piston on my 95 XLT sp and I was wondering if any-
body knows the torque specifications for the cylinder and the heads. I was also
wondering if there is anything else I should check before I put it back togather.
thanks :help:

cylinder head:
8mm=17-18 ft lbs
10mm=24-26 ftlbs
crankcase:
8mm=17-18 ft lbs
10mm=23-25 ft lbs
cylinder stud nuts:
24-28 ft lbs
flywheel:
60-65 ft lbs
these specs are out of my clymer manual,hope it helps

Should check to see what caused the first piston failure You can spend alot of money on pistons if you don't find the problem.first see what part of the piston failed,the will give you clues where to look.Check the carbs anyway,also if you blow a drive belt in the past,see if any parts off the belt damaged the seal.Good Luck